Stainless steel chain is considered bad manifold minimum tensile strength values ??occur in the load is not increased ^ deforms to continue to increase at the initial point of 201 stainless steel chain size, improve the chain, pulling curse on this point must exceed the company's chain provisions . If the damage occurred in connection with the chuck 眹 at the chain, the test is considered invalid. Tensile testing is considered destructive testing. Although the chain after a Ning pull cymbals LOADING did significant damage to the sample, six points of the chain, but the chain pull force has exceeded the yield limit. Therefore, after the chain tension after the test will not be used. Qiao seek above does not apply to bent plate link, coupled with the crucible or chain link member, which should reduce the tensile strength of the chain. Related reference coefficient of stainless steel mesh belt, from the following two perspectives. First, the main technical parameters: 1, temperature: -40 ℃ ~ 1050 ℃ 2, belt width: 150 ~ 4200mm 3, the edge of the form: Flange, Heading, welding and other forms of 4, with net grid and belt speed: 0.15 ~ 0.50m / min Second, the performance characteristics: 1, reasonable design, compact structure, specifications, easy installation, reliable operation. 2, having a satisfactory anti-shrink at negative and high temperatures, oxidation, metal mesh fracture resistance. 3, with good corrosion resistance, wear resistance, high temperature properties. Stainless steel chain manufacturers, 西卢 chain network Factory (certification), chain by chain network Ningjin 西卢 plant. Ningjin Xi Lu chain network Factory (www.njxllw.cn) Shandong Dezhou, chains, sprockets leaders, over the years, the company implement the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Xi Lu chain network in the plant leadership with the staff warmly welcome all inquiries negotiations to create Xi Lu chain network plant a better future.