High-quality stainless steel mesh belt _ 西卢 chain network Factory (certified) _ stainless steel mesh belt by Ning County 西卢 chain network plant. Ning County Xi Lu chain network Factory (www.njxllw.cn) is specialized in the "stainless steel mesh chain, chain, sprockets, food machinery" of the enterprise, the company of "honesty, hard service" concept, to provide you with the most quality products and services. Welcome to inquire! Contact: Lujing Li. According to specifications: Chain label - pitch P --- chain rod pitch P1- chain rod diameter D - mesh wire diameter D1 - belt pitch L - belt pitch J (P) ---- (p) - ---- (p1) --------- (D) ------- (D1) ----- (L) -------- (J) C2042- -25.40mm - 25.40 × * Day --- 5 ~ 8mm - 1.0 ~ 1.6mm - 3 ~ 19mm ----- 6.35 ~ 25.4mm C2052--31.75mm - 31.75 × * section --- 6 ~ 10mm-1.2 ~ 2.0mm - 5 ~ 21mm ----- 6.35 ~ 31.75mm C2062--38.10mm - 38.10 × * section --- 8 ~ 12mm-1.5 ~ 2.0mm - 8 ~ 21mm-- --- 6.35 ~ 38.1mm C2082--50.80mm - 50.80 × * Festival --10 ~ 12mm-1.5 ~ 3.0mm-10.5 ~ 21mm-12.7 ~ 50.8mm C2160--101.6mm - 101.6 × * Festival - stainless steel mesh belt 10 ~ 14mm-1.5 ~ 4.0mm-10.5 ~ 27mm-12.7 ~ 50.8mm stainless steel mesh belt conveyor in the food industry, which is frequently used, the following describes the solid stainless steel mesh belt rust remover recipe: combine easy operation transport, and rapid, less pollution, low cost, and other factors to consider stainless steel mesh belt manufacturers, solid stainless steel rust remover can solve the above problems big Qi stainless steel mesh belt, this solid herbicides selected with sulfuric acid erosion, supplemented by the accelerating effect of fluoride quality stainless steel mesh belt, adding kaolin as the main oxide additives made of solid stainless steel cleaner, easy to use and fast, the formula is as follows: H2SO4 (98%) 25 ~ 30% HF 20 ~ 25% HNO3 5% kaolin 40 to 50% nonylphenol ether 0.1% 0.5% pure methenamine 5 ~ 10% C2H5OH right amount manufactures light gray powdery solid, when used with a : 1 ratio by volume concentrated solid product mix with water, stir to give a syrup cleaner, applied to the surface of the stainless steel forgings with a small amount of oil and rust, and stay for about 10 to 15min, rinse with water after the end natural dry or wipe with a cloth.